![]() ![]() Initially this was not important for large industrial/commercial systems and for home computers, and systems typically operated at full power consumption all the time, with cooling systems also designed to operate at maximum cooling capacity all the time. With the developing social interest in energy conservation, the concept of designing systems to only consume as much power as is needed at a particular moment has helped to reduce both power consumption and system noise. This combination could lead to a system with a large number of internal spot-cooling fans that is overheating because there is poor overall airflow into and out of the case. Sometimes fan airflow is not coordinated, such as with the power supply and case fans both blowing air in or sucking air out, with no other venting. Multiprocessor systems such as the Pentium Pro typically needed a separate spot-cooling fan for each CPU.Ĭomputer cases often have not been designed to consider the overall airflow of the system, while spot-cooling fans only focus on cooling a specific location without regard to where the exhaust air is going.The development of 3D cards working in tandem required separate spot-cooling fans for each card. But with the development of the 3D graphics card, it became common for the video card to have its own fan, separate from a general case/system fan. Originally, video display controllers were fairly low power devices without any need for active cooling. ![]() ![]() The sole purpose of the fan was to move heat from a small concentrated location under the heatsink into the larger air mass inside the computer case.Īs desktop computers grew in performance, more fans were included to provide spot-cooling in many more specific locations where heat dissipation was needed, without regard to overall airflow or trying to do thermal analysis of cooling efficiency. There was no regard for where the intake air came from, or where exhaust was going. Beyond that point, a fan would be installed over the CPU heatsink to blow air straight down onto the processor, in what is known as spot-cooling. Processors up to about 60 megahertz did not require anything more than a single case fan and a passive heatsink. If there was a fan, it was a low-speed fan only used to cool the power supply, such as in the IBM PC XT.įan noise only started to become an issue as CPU processing power increased. With the development of the home computer, early systems such as the Commodore 64 were very low wattage and were often fanless. For these systems noise was not an important issue. Prior to about 1975, all computers were typically large industrial/commercial machines, often in a centralized location with a dedicated room-sized cooling system. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |